Before & After Gallery in Santa Clara, CA

Real Santa Clara fixtures, before and after

Every pair below is a real surface we refinished somewhere in Santa Clara — a cast-iron tub in the Old Quad, a gelcoat shower in a Lawrence Station condo, a cultured-marble vanity in Rivermark, dated tile in Forest Park. We shoot the "before" the moment we walk in and the "after" from the same spot once the topcoat has cured, so what you drag past is an honest comparison, not two different bathrooms. Nothing was replaced; the same fixture was cleaned, repaired, etched or scuff-sanded, primed and resprayed. Want the full story behind each one? Read the detailed Santa Clara reglazing case studies — what we found, the prep, the coats, the turnaround and the cost — or see what colors are possible on our reglazing colors page.

What you're looking at in each pair

The "before" side is honest about the kind of wear we see across Santa Clara. Cast-iron and porcelain tubs in the postwar Old Quad and around Bowers go chalky and pick up rust around the drain and overflow after decades of use. The gelcoat fiberglass tubs and showers in the 1980s–2000s condos of Lawrence Station, Santa Clara Square and Rivermark fade and develop crazing — that fine spiderweb cracking in the surface layer. Cultured-marble vanities yellow and etch where toothpaste, perfume and hard water sit on them. None of that scrubs out, because the damage is in the surface, not on it.

The "after" side is the same fixture once the surface is renewed. Each one was cleaned down to a sound substrate, repaired where it was chipped or cracked, etched or scuff-sanded so the primer could bond, and sprayed with several thin coats of acrylic-urethane. The result is a hard, even gloss that's ready to use 24–48 hours after the final coat. Curious what each one cost? The pricing page breaks it down by fixture, and the process page walks through every step in detail.